8 Cadillac V8 displacements from the 1949 331 to the 1980 368

Cadillac launched its overhead-valve V8 for 1949 at 331 cubic inches. Over the next three decades, Cadillac V8 displacements grew in steps to 500 cubic inches, then shrank twice between 1977 and 1980.

Below, the eight sizes run in order, from the 1949 original to the 1980 368. Each rating belongs to the year shown, because Cadillac changed the numbers often. However, some mid-1970s and later figures are SAE net rather than gross, so they read lower on paper.

1. 1949–1955 331

A 1949 Cadillac Series 62 convertible, from the year of the 331, the first of the Cadillac V8 displacements
Image Credit: Rex Gray from Southern California – CC BY 2.0/Wiki Commons

The original V8 used a 3-13/16-inch bore and a 3-5/8-inch stroke for 331 cubic inches. With 7.5:1 compression, it made 160 hp at 3,800 rpm and 312 lb-ft at 1,800 rpm, Tomorrow’s Technician reports.

SlashGear gives the same 160 hp and 312 lb-ft for a 1949 Coupe de Ville. After that, the ratings climbed every few years. By 1955, the Eldorado version reached 270 hp, according to SlashGear, and Over-Drive’s 1955 spec sheet agrees.

2. 1956–1958 365

A 1956 Cadillac Eldorado Biarritz, from the first year of the 365
Image Credit: Matti Blume – CC BY-SA 4.0/Wiki Commons

For 1956, Cadillac enlarged the V8 to 365 cubic inches. With 9.75:1 compression, it made 285 hp, Tomorrow’s Technician says. Over-Drive’s 1956 fact sheet gives the same 285 hp at 4,600 rpm. In addition, it lists a 305-hp Eldorado version at 4,700 rpm that year.

Then the numbers kept rising. The 365 reached 300 hp in 1957 and 310 hp in 1958, SlashGear notes. Meanwhile, the 1958 Eldorado’s three-carburetor version made 335 hp, a figure the Wikipedia engine history also lists.

3. 1959–1963 390

A red 1959 Cadillac Eldorado Biarritz with the 390 V8 era styling
Image Credit: AlfvanBeem – CC0/Wiki Commons

Next, a longer stroke took the V8 to 390 cubic inches for 1959. The base engine made 325 hp at 4,800 rpm, while the Eldorado’s tri-power version made 345 hp, Over-Drive’s 1959 spec sheet shows.

For 1963, Cadillac redesigned the engine with shorter connecting rods and a relocated accessory housing, the Wikipedia history says. Still, the redesigned 390 kept the 325-hp rating, and SlashGear also puts it at 325 hp.

4. 1964–1967 429

A 1965 Cadillac DeVille convertible from the 429 years
Image Credit: Alexander Migl – CC BY-SA 4.0/Wiki Commons

In 1964, Cadillac bored the engine to 4.13 inches and stroked it to 4.00 inches for 429 cubic inches. As a result, it made 340 hp at 4,600 rpm and 480 lb-ft at 3,000 rpm, Tomorrow’s Technician reports.

In fact, the 429 was still basically the 1949 design, the same source notes. The Wikipedia history lists the same 340 hp and 480 lb-ft, and it says Cadillac used the 429 through the 1967 model year.

5. 1968–1974 472

A 1968 Cadillac Fleetwood Eldorado, the first year of the 472
Image Credit: sv1ambo – CC BY 2.0/Wiki Commons

For 1968, the V8 grew again. Its bore and stroke went to 4.30 by 4.06 inches for 472 cubic inches and 375 hp, according to Tomorrow’s Technician.

Meanwhile, torque came in at 525 lb-ft, SlashGear says. The Wikipedia history adds the engine speeds, 375 hp at 4,400 rpm and 525 lb-ft at 3,000 rpm. After that, it adds, Cadillac used the 472 through 1974.

6. 1970–1976 500

A 1970 Cadillac Eldorado convertible, the first year of the 500
Image Credit: Ermell – CC BY-SA 4.0/Wiki Commons

The 500 arrived on September 18, 1969, for the 1970 Eldorado only. It made 400 gross hp at 4,400 rpm and 550 lb-ft at 3,000 rpm, Mac’s Motor City Garage reports. In fact, SlashGear calls it the first Cadillac engine to top 400 hp, if only barely.

Later, emissions tuning took its toll. By 1975, every Cadillac except the Seville offered the 500, at 210 net hp, Mac’s says. By 1976, its last year, the rating fell to 190 hp, a figure the Wikipedia history also gives.

7. 1977–1979 425

A 1977 Cadillac Sedan de Ville, the first year of the 425
Image Credit: Mick from Northamptonshire, England – CC BY 2.0/Wiki Commons

For 1977, Cadillac cut the big V8 from 500 to 425 cubic inches. With a carburetor, it made 180 hp and 320 lb-ft. With the optional electronic fuel injection, it made 195 hp, Curbside Classic reports.

At the same time, every Cadillac except the Seville carried the 425, Tomorrow’s Technician notes. By 1979, the 180-hp 425 came as standard in the DeVille and Fleetwood, Consumer Guide lists.

8. 1980 368, the last of these Cadillac V8 displacements

A 1980 Cadillac Sedan DeVille, the year of the 368
Image Credit: That Hartford Guy from Hartford, Connecticut, USA – CC BY-SA 2.0/Wiki Commons

For 1980, Cadillac shrank the bore from 4.082 to 3.80 inches and kept the 4.06-inch stroke. As a result, the 368 made 150 hp and 265 lb-ft with a carburetor, Curbside Classic reports.

For 1981, Cadillac added V8-6-4 cylinder deactivation to the 368, rated at 140 hp and 265 lb-ft, Jalopnik notes. However, the V8-6-4 lasted only one year in most cars. After that, Cadillac kept it in its limousines, Tomorrow’s Technician says.

More from Fast Lane Only

This article was created with the help of AI and was reviewed and edited by Fast Lane Only editors before publication.

Bobby Clark Avatar